Satillite Dish On Metal Roof

To properly install a mount on the roof a rafter has to be located underneath the shingles.

Satillite dish on metal roof.

An alternative satellite dish mounting location is at the top of a sturdy metal or wood pole. Every satellite dish system comes in two or more parts. Satellite dish installationsmast installation. So they often unbolt the footplates and remove the dish.

Many who aren t intimately familiar with these systems including roofers might see it as one big hunk of metal. A dish mast installed on a traditional wood framed structure should be secured with 6 lag screws. These holes pierce all layers or protection that your bryan roofer installed including the waterproof underlayment and seals. The pole gives the dish more height without it needing to be on the roof.

The dish assembly and the mounting bracket. It only intersects with their work area at one location the roof. How can i install a satellite dish on my roof without causing a leak. The pole should be adequately anchored with concrete under the ground to stabilize the dish during windy weather.

Even a small 18 inch dish can excerpt a lot of force on a dish mast. As opposed to your roof a pole offers you much more flexibility for satellite placement and can help you avoid signal loss if you choose a completely unobstructed location. The mast must be secured to withstand years of wind loading. One of the best ways to set up a dish is by anchoring a metal pole in the ground with concrete then mounting the dish on top of it.

Then holes are drilled into your roof to secure it in place. Two in the center secured into a wall stud or roof rafter and four secured in the corners of the mount. Usually four to six holes are drilled through the roof to complete the install. The holes newly created large enough to fit a half inch bolt and are about 3 inches long.

Normally a rubber sheet will be installed with the screws to ensure that it stays and doesn t leak.