Tips For Vinyl Wrapping A Car

Using moderate pessure on your squeegee apply the film while pushing out trapped air from beneath starting from the middle outward.

Tips for vinyl wrapping a car.

Most companies who work on vinyl wrapping or wrap paint as it s sometimes referred to use what s called cast vinyl the highest tier of vinyl on the wrapping market. There is also another great thing about wrapping in sections. Cut the vinyl wrap not the vehicle. With air release vinyl wrap you can press the air easily.

After the vinyl sheet has adhered to the car body over the thread the thread is sharp. Vinyl wrapping on your vehicle will not only last a long time but it s also going to look good doing it. The vehicle surface temperature must be at least 60 degrees fahrenheit. We recommend to have the car generally cleaned with car wash soap avoid using cleaners with waxes.

A product called knifeless tape applies a filament thread made of thin kevlar to the car body under the vinyl. Avoid using chrome is this is your first time applying vinyl wrap. Make sure your material is larger than needed for easier handling. Keep in mind that the vehicle s paint is lurking under your blade.

Avoid using vinyl on wooden surfaces. Once the vinyl is smooth it s time to remove the excess material. This will help if you need to lift the vinyl to remove any air you can t smooth out. Don t cut any excess until you re positive there are no air bubbles.

1 the first step is to clean the surface with paint safe grease and wax remover to remove any dirt or grime on the surface. Use vinyl wrap on smooth substrates like glass corrugated plastic and painted aluminum. Then proceed to rinse the surface with water. Purchase roughly 15 20 feet 4 6 6 1 m more vinyl than you think you ll need in case you mess up any of the panels.

Prepping for a vinyl wrap installation includes making sure your vehicle is free of dust mud wax oil protective type products and other agents that may prevent the vinyl from adhering to the vehicle surface during the installation process. Once you have a starting peel back the liner and place the vinyl wrap onto the target surface.