Smartthings Garage Door Opener Device Handler

In looking at the works with smartthings page it seems that there isn t an opener that inherently connects to smartthings as there are only 2 add on devices that connect to it gocontrol and iris.

Smartthings garage door opener device handler.

It looks like my current garage door opener is failing and as i replace it i would like to get something that works with smartthings. From the home screen touch menu and select devices. To do this in the smartthings app. Linear gocontrol garage door opener with low battery sensor and switch capability this custom z wave garage door device handler allows you to control the garage door when people arrive leave from the smartthings doors and locks section apps.

This leaves me with two options. Virtual garage door manager and controller on overwhelming requests from users. Configure and automatically install up to 5 virtual. Hello all ok i m pretty excited with this device.

After some digging around it seems that i can solder the linear garage door controllers to the circuit board of a spare push button garage door opener that is used inside of a vehicle. Also adds into google assistant one thing though you have to add it separately into both google and smartthings. Right now i am trying to get it working on the dashboard but the smartthings door type of garage door is currently limited to a standard on off relay only. To reset the gocontrol linear garage door opener gd00z 4 if the gocontrol linear garage door opener gd00z 4 was not detected you may need to reset or exclude the device before it can successfully connect with the smartthings hub.

I also noticed that not all of them have a battery indicator for the tilt sensor. It also allows you to control the garage door like a regular switch on off to open close respectively. This solution allows you to build your own custom bespoke garage door opener using a relay and a door open close sensor or a tilt sensor and optionally integrate other sensors controls in to your virtual garage door controller. Smartthings device handler and smartapp to convert a z wave relay into a garage door opener button.

I was hoping to eliminate the need for a separate tilt sensor but i imagine it s going to take some additional work on the device type to achieve that. I very much want to say hey google open the garage door while i m still half a block from home and have the door open and waiting for me when i. Attempt to retry close open operations if they don t succeed automate. Key features of this solution.

The meross msg100 garage door opener works perfectly with smartthings app. Option 1 just go out and buy a myq gateway that will control both of my garage door openers. Combines an actuator switch device and multisensor contact acceleration into a single logical garage door device capability doorcontrol properly reflects the state of the door if opened closed externally door button garage remote etc opens closes immediately when you tell it to what it doesn t do. There seem to be quite a few different variations of the code and i wonder if there is a favorite of the bunch.

But hey it s pretty good for 34.